The F-16TEL is used for carrying 16 phone lines over fiber optic cable. Extend Telephone over Fiber applications offer a secure connection that is impossible to bug. The PSTN two-wire POTS telephone port can be configured either as an FXO (PBX trunk) or FXS (telephone set/fax machine/dial-up modem) device just by a simple DIP switch setting. Using a pair of these devices, 16 independent telephone lines can be extended over a fiber link. The F-16TEL provides full service for features like caller ID. The converter can be used in service mode, allowing the connection of 16 telephone sets. The F-16TEL is a simple and reliable solution for data carriers and service providers for Telephone over Fiber links.
• Extend telephone voice transmission up to 20 / 40 / 80km over fiber (model dependent)
• The base model works up to 20Km over single mode fiber or up to 3000 feet over multimode fiber
• Supports telephone voice transmission
• Supports caller ID pass-through
• The Tx Transmitter) connects to FXS (telephone set/fax machine/dial-up modem)
• The RX (receiver) connects to FXO - ( (PBX trunk)
|
16 CH Telephone FXO/FXS Singlemode Fiber Transmitter for up to 20Km (single mode) or up to 3000 feet (multimode fiber) • The Tx Transmitter) connects to FXS (telephone set/fax machine/dial-up modem) • The RX (receiver) connects to FXO - ( (PBX trunk) |
|
16 CH Telephone FXO/FXS Singlemode Fiber Transmitter for up to 40Km (single mode) or up to 3000 feet (multimode fiber) |
|
16 CH Telephone FXO/FXS Singlemode Fiber Transmitter for up to 80Km (single mode) or up to 3000 feet (multimode fiber) |
|
16 CH Telephone FXO/FXS Singlemode Fiber Transmitter for up to 120Km (single mode) or up to 3000 feet (multimode fiber) |
| *All Specifiactions Subject to Change Without Notice | |||
| Optical Interface: | |||
|
ST/PC | ||
|
SM 20/40/80120km MM up to 3000feet | ||
|
MM 1310nm, SM 1310, 1550nm, WDM 1310Tx/1550Rx, 1550Tx/1310Rx | ||
| Electrical Interface | |||
|
RJ-11 | ||
|
600 ohms, Coding : 16 bits liner, Loop Current : 10~100mA Ring Frequency : Acceptable 20 ~50Hz, Insertion Loss: 0.0 ± 1.0dB at 1000H |
||
|
Impedance : 600 ohms, Coding : 16 bits liner, Dial: DTMF and Dial Paul, Battery Source: 48VDC ± 4 |
||
|
Sine Wave | ||
|
20/25/30/50 Hz selectable | ||
|
FXS to FXS : On / 1 sec, Off / 2 sec | ||
|
Reproduces the cadence detected by FXO Insertion Loss 0.0 ± 1.0dB at 1000Hz REN: 4.0B(Ring Equivalence Number |
||
|
Power, FX Link, Phone Act, Test | ||
|
AC 100-240V 50/60Hz) | ||
|
5 W | ||
|
480mm x 225mm x 44mm | ||
|
0~50°C (Operating) 0~70°C (Storage) |
||
|
CE, FCC, LVD, RoHS | ||
|
125,000 h (25°C) | ||
8 Líneas Telefónicas Analógicas más de transceptor de Fibra
Extender independientes de 8 teléfonos de más de 1 cable de fibra óptica. 8 Canales telefónicos sobre transceptor de fibra para asegurar las líneas telefónicas. Estas unidades de transporte de la norma teléfono analógico de la se?al de punto a punto sobre cable de fibra óptica y son imposibles de toque.
Fast Ethernet 10/100 Mbps Más de 1 Convertidor de Medios de Fibra SC / UPC
Bi-direccional de Ethernet de 10/100 de Transporte de más de una fibra (SC/PC), el Convertidor tiene 1 solo conector de fibra óptica para la transmisión a 1310 nm y recibir a 1550 nm, y un puerto RJ-45 10/100 para 100FX Sola Fibra WDM Convertidor de Medios de comunicación. Un Solo Modo de fibra permitirá la transmisión bidireccional de datos entre Tx y Rx simultáneamente de hasta 20km. Las unidades están etiquetados como a Y B; que es un conjunto.
EN
